Please explain the operation of the "wait to start" light, its
What Controls The Wait To Start Light. I changed the selinoid last night and the light would come on for a couple on secounds and then go off. Web the pcm controls the wts light and i would guess that your wiggling the fuses caused this fuse to make contact again.
Please explain the operation of the "wait to start" light, its
Web illuminate if glow plug heat is necessary as a starting aid. Web the pcm controls the wts light and i would guess that your wiggling the fuses caused this fuse to make contact again. The light should always illuminate briefly, when the ignition key is in the on. When the ignition switch is. Try it again, but this time i wait till after light goes out, then i watch to see voltmeter jump in positive direction and she starts. Web then i turn the key back and wait 5 secs. I changed the selinoid last night and the light would come on for a couple on secounds and then go off. 2.turn the key on and look for an initial reading of 160 amps or more. Web i have 98.5 and my wait to start light will not come on when you turn the key to the on position right away. This morning i tried to start and.
For most diesels, the light turns off when the glow plugs reach the established. The light should always illuminate briefly, when the ignition key is in the on. Try it again, but this time i wait till after light goes out, then i watch to see voltmeter jump in positive direction and she starts. I changed the selinoid last night and the light would come on for a couple on secounds and then go off. Web the wait to start light was dim and flickering when trying to start it. It was cranking over but would not start so i had it towed home. Web illuminate if glow plug heat is necessary as a starting aid. Check all 8 glow plugs. Web i have 98.5 and my wait to start light will not come on when you turn the key to the on position right away. Web this message reminds you that the diesel engine may take a few minutes to start. Web 1.install the clamp on meter around the two output wires from the glow plug relay.
